WINDOW / GLASS POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL
CAUTION / NOTICE / HINT
- HINT:
- ·
Use the same procedure for the RH and LH sides.
·The procedure listed below is for the LH side.
·Use the same procedure for RHD and LHD vehicles.
·The procedure listed below is for LHD vehicles.
PROCEDURE
1. PRECAUTION
- NOTICE:
-
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
4.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)
69284C
6.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
74642A
7.REMOVE FRONT DOOR ASSIST GRIP COVER LH
67602
8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
67832
9.REMOVE FRONT DOOR SERVICE HOLE COVER LH
68102
10.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
69802
11.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
85720C
12.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.
- NOTICE:
-
Be careful when removing the screws as the motor may fall and become damaged.
.png "close")